With the rapid development of urban construction in our country, the use rate of floor scrubber is becoming more and more widespread. Only by selecting the appropriate operation method during the whole operation can better use effect be achieved. For better application, let's understand together below. What are the overheating problems of the motor of the lower scrubber?
One of the core components of the floor scrubber is the drive motor. If the bearing is overheated, it is mainly due to the wear of the bearing itself, which constitutes an excessively large open space, which constitutes oscillation and the heat generated by the trigger. Generally, it can only be replaced. Sweeping the bore is when the bearing is worn out, there is no space between the rotor and the stator, and they directly conflict with each other. This will seriously damage the stator winding, and only the bearing can be replaced. The stator winding of the motor is short-circuited, and the motor of the automatic scrubber cannot be initiated. The motor is overloaded. Normally, it is not possible. However, the operator does not use it properly. For example, the floor scrubber is heavy, but the motor is only used to drive the floor scrubber to walk, so it cannot be used for climbing. , It will undoubtedly increase the load of the motor and shorten the life of the motor.
In order to make better use of the automatic floor scrubber, maintenance work should be done normally. Maintenance of the scrubber motor Regularly check the lubricating oil, whether the motor shaft is bent, or check whether the motor is wet and grounded. It can be used. Measured by a megohmmeter. The main part of the scrubber is the generator. When the generator shows shortcomings, it is necessary to repair it in time. Otherwise it will affect the overall function of the fully automatic floor scrubber. So what are the elements of the generator's shortcomings, and how should these shortcomings be cleaned up. The bearing lacks oil or the space is too small, which constitutes the bearing violent resistance to trigger the overheating phenomenon. Punctually protect the generator, and if there is a shortage of oil, add complex calcium-based grease in time, usually covering 2/3 of the bearing cavity.
The above is about the overheating of the scrubber motor. Choose the appropriate method according to the specific operating regulations to avoid unnecessary damage caused by blind operation. If you have other questions, you can call for consultation. I hope the above content will help everyone.