The electric sweeper is mainly used to clean domestic garbage such as cement, asphalt, ceramic tiles and other ground dust, stones, leaves and so on. It is used frequently in daily life, especially in factories, properties, health departments, etc. The sweeper is the basic cleaning equipment, and sweeper consumables and other supplies are regularly purchased every season.
Do you all know about factory sweepers? Do you know the basic components and operating methods of the sweeper's dial? Users who don’t know come to find out!
The basic buttons of the operation panel of the factory electric sweeper:
Cleaning switch, water spray switch, headlight switch, horn switch, turn signal switch, vacuum vibration switch, forward and backward switch, power indicator, accelerator pedal, brake pedal, large garbage pedal, emergency stop switch, key switch, parking Handbrake, front brush lift button, front brush retractable button, front brush switch.
The basic operation method of factory electric sweeper:
Start: insert the key and turn to the NO position. The meter displays and the warning light flashes.
Walking: After turning on the power, check whether the handbrake is pulled up, and turn on the master switch forward or backward as needed.
Sweeping the floor: Press the sweeping switch, each motor starts to rotate, the main brush and side brush will automatically drop, and the floor will be swept automatically.
Vibrating the dust: When cleaning the ground, it is required to vibrate the dust for 20-40 seconds every 15-30 minutes.
Cleaning is complete: Turn off the cleaning button, raise the side brush of the main brush, turn on the dust for 40 seconds and empty the trash can, pull up the handbrake, and remove the key.
The basic maintenance method of factory electric sweeper:
Before each use of the factory sweeper, the brake system of the sweeper must be checked and the interior must be thoroughly cleaned regularly to prevent excessive dust from causing short circuits in electrical components.
Every time you use the sweeper, check whether the main brush and side brush of the factory sweeper are entangled.
Check the ground clearance of the main brush and side brush of the cleaning vehicle weekly.
Clean the filter element thoroughly every month. If the dust is severe, the cycle needs to be shortened to weekly. Check if the filter element scraping is worn.